Structural and lithium intercalation studies of Mn(0.5−x)CaxTi2(PO4)3 phases (0≤x≤0.50)

Materials from the Mn_(0.5−x)Ca_xTi₂(PO₄)₃ (0≤x≤0.50) solid solution were obtained by solid-state reaction in air at 1000 °C. Selected compositions were investigated by powder X-ray diffraction analysis, ³¹P nuclear magnetic resonance (NMR) spectroscopy and electrochemical lithium intercalation. The structure of all samples determined by Rietveld analysis is of the Nasicon type with the R space group. Mn²⁺/Ca²⁺ ions occupy only the M1 sites in the Ti₂(PO₄)₃ framework. The divalent cations are ordered in one of two M1 sites, except for the Mn_0.50Ti₂(PO₄)₃ phase, where a small departure from the ideal order is observed by XRD and ³¹P MAS NMR. The electrochemical behaviour of Mn_0.50Ti₂(PO₄)₃ and Mn_(0.5−x)Ca_xTi₂(PO₄)₃ phases was characterised in Li cells. Two Li ions can be inserted without altering the Ti₂(PO₄)₃ framework. In the 0≤y≤2 range, the OCV curves of Li//Li_yMn_0.50Ti₂(PO₄)₃ cells show two main potential plateaus at 2.90 and 2.50–2.30 V. Comparison between the OCV curves of Li//Li_(1+y)Ti₂(PO₄)₃ and Li//Li_yMn_0.50Ti₂(PO₄)₃ shows that the intercalation occurs first in the unoccupied M1 site of Mn_0.50Ti₂(PO₄)₃ at 2.90 V and then, for compositions y>0.50, at the M2 site (2.50–2.30 V voltage range). The effect of calcium substitution in Mn_0.50Ti₂(PO₄)₃ on the lithium intercalation is also discussed from a structural and kinetic viewpoint. In all systems, the lithium intercalation is associated with a redistribution of the divalent cation over all M1 sites. In the case of Mn_0.50Ti₂(PO₄)₃, the stability of Mn²⁺ either in an octahedral or tetrahedral environment facilitates cationic migration.     

Analysis of Spectral Reflectance Using Normalization Method from Endoscopic Spectroscopy System

Objective assessment of gastrointestinal mucosal color is extremely important in the endoscopic diagnosis of digestive tract disease. In this paper, we propose a method to clarify the spectral characteristics of gastric and colon cancer. A large number of spectral reflectance data of mucous membrane are measured by the endoscopic spectroscopy system (ESS) in the National Cancer Center Hospital East, Kashiwa, Japan and the Department of Internal Medicine, Self-Defense Force Center Hospital, Tokyo, Japan. We assume that early cancer appears primarily in the spectral data of short wavelength, because it is usually present in a superficial cell where short wavelength light is scattered more strongly than long wavelength light. To identify the features in the short wavelength components, the spectral reflectance was divided by the reflectance of a long wavelength. We investigated the possibility of distinguishing early cancer from normal spectral data through statistical analysis, employing the projection axis as the mean difference between them. Early cancer and normal spectral data were projected on the projection axis, and the Student’s T-test was applied to evaluate the mean of the distribution between these data.     

A high-pressure Raman and X-ray diffraction study of the perovskite SrCeO3

A high-pressure structural study of SrCeO₃ has been performed at room temperature by Raman spectroscopy and X-ray diffraction up to 32 and 45 GPa, respectively. A first-order reversible phase transition is observed at about 12 GPa in both techniques. A second weak structural change, taking place between 18 and 25 GPa, can be suspected from Raman data. The increase in the number of Raman bands and diffraction lines is an indication that the symmetry is lowered and the compound does not evolve towards the ideal cubic perovskite structure. A Rietveld analysis of X-ray data was performed for the low-pressure phase and the atomic positions and the cell lattice parameters variations are reported in this paper. The volume compressibility derived from Raman modes (5.6×10⁻¹² Pa⁻¹), involving mainly bond-stretching for each type of polyhedron, is found to be close to the one obtained from volume cell variations measured by X-ray diffraction (7.9×10⁻¹² Pa⁻¹).     

CH分子束的强度与CH_4/He混合配比的关系及CH(A~2Δ)振转温度的计算

为了获得CH分子束及其相关特性,以氦气为载气,利用直流脉冲放电技术产生了CH分子束。实验记录了放电时间相对于脉冲分子束不同延时CH光谱信号强度的变化,放电相对延时为460μs左右获得最大的信号强度。研究了在保持CH4/He总气压3 atm和放电电压-4 kV不变的条件下CH分子束强度与不同配比的关系,建立了理论模型,对实验数据进行了理论拟合,拟合曲线与实验结果符合较好,配比为1%(甲烷与氦的气压比为1∶99)左右能够维持较稳定的放电现象和较强的放电强度而获得较强的CH自由基束流。在这一配比下对CH(A2Δ-X2Π)(0,0)带发射光谱进行探测和分析,获得CH(A2Δ)转动温度和振动温度分别为2455 K和4575 K,并估计此时每个脉冲中大约包含1013~1014个CH自由基。     

NaOH电解液改善MH/Ni电池自放电性能的机理研究

以NaOH电解液代替KOH能够明显改善MH/N i电池的自放电性能和高温(60℃)充电效率.电化学阻抗和循环伏安测试表明,NaOH电解液的作用可能是改变了H原子于负极表面的吸(脱)附行为,并在一定程度上抑制了负极的析氢过程,从而改善了电池的自放电性能.     

CO-laser photoacoustic detection of phosgene (COCl2)

Detection of COCl₂, a highly toxic gas in chemical industry, using laser photoacoustic spectroscopy is presented. The spectrophone system used has a broad band LN₂ cooled CW CO laser as a source of radiation, which operates from 4.8–8.4 um in the mid-infrared. Using an extracavity open longitudinal resonant cell, absorption signals to about 30 CO laser lines in the 5.45 um region could be observed. detection sensitivity has been estimated to be ppb order.This work has been supported by the NSFC     

HeI photoelectron spectroscopic (PES) and quantum chemistry study on the dimeric compound of 2(5H) furanone

The He1 photoelectron (PE) spectra of both 2(5H) furanone and itstrans-chair-dimeric-compound (t-c-DFN) are reported. The assignment of the PES bands is made on the basis of band shapes, the PES results of the molecules which have the similar atomic groups, and the restricted Hartree-Fock (RHF) calculations for the molecules studied. From the results of both PES experimental and theoretical calculations, it is proved that the ionization potential (IPS) of the HOMO for the dimeric-compound is lower than that of the HOMO for the monomer. And the total energy computed for thet-c-DFN is the lowest in the four possible configurations of dimeric-compounds of 2(5H) furanone. Therefore the synthesis oft-c-DFN is also the easiest. Project supported by the National Natural Science Foundation of China.     

Effects of UV photon irradiation on SiOx (0 < x < 2) structural properties

Thin films of a-SiO_x (0 < x < 2) were prepared by reactive r.f. magnetron sputtering from a polycrystalline-silicon target in an Ar/O₂ gas mixture. The oxygen partial pressure in the deposition chamber was varied so as to obtain films with different values of x. The plasma was monitored, during depositions, by optical emission spectroscopy (OES) system. Energy dispersive X-ray (EDX) measurements and infra-red (IR) spectroscopy were used to study the compositional and structural properties of the deposited layers.Structural modifications of SiO_x thin films have been induced by UV photons’ bombardment (wavelength of 248 nm) using a pulsed laser. IR spectroscopy and X-ray photoemission spectroscopy (XPS) were used to investigate the structural changes as a function of x value and incident energy. SiO_x phase separation by spinodal decomposition was revealed. The IR peak position shifted towards high wavenumber values when the laser energy is increased. Values corresponding to the SiO₂ material (only Si⁴⁺) have been found for laser irradiated samples, independently on the original x value. The phase separation process has a threshold energy that is in agreement with theoretical values calculated for the dissociation energy of the investigated material.For high values of the laser energy, crystalline silicon embedded in oxygen-rich silicon oxide was revealed by Raman spectroscopy.     

Formation of Fe i –B pairs in silicon at high temperatures

We report on the detection of Fe _i –B pairs in heavily B doped silicon using ⁵⁷Fe emission Mössbauer spectroscopy following implantation of radioactive ⁵⁷Mn⁺ parent ions (T _1/2?=?1.5 min) at elevated temperatures >?850 K. The Fe _i –B pairs are formed upon the dissociation of Fe _i –V pairs during the lifetime of the Mössbauer state (T _1/2?=?100 ns). The resulting free interstitial Fe_i diffuses over sufficiently large distances during the lifetime of the Mössbauer state to encounter a substitutional B impurity atom, forming Fe _i –B pairs, which are stable up to ～1,050 K on that time scale.     

A Mössbauer spectroscopic study of an industrial catalyst for dehydrogenation of etylbenzene to styrene

Iron oxide catalyst with spinel structure used for dehydrogenation of ethylbenzene is one kind of important catalyst in petrochemical industry. In this work several series of industrial catalyst were prepared with different components and different manufacturing processes. Mössbauer Spectroscopy has been used to determine the optimal components and the better manufacturing process for spinel structure formation. The results may prove useful for producing the industrial dehydrogenation catalyst with better catalytic property.